Page 1 of 1

SAM3U-EK available

Posted: Fri Jul 17, 2009 1:33 pm
by bdenis

Re: SAM3U-EK available

Posted: Wed Jul 22, 2009 1:35 pm
by nat
OK sounds good :-)

Re: SAM3U-EK available

Posted: Mon Jul 27, 2009 10:09 am
by michael123
We received ours a week ago.

Unfortunately we had problems with it from the start and, before we could characterise the issue, the board stopped working altogether.

Now it only boots properly when the ERASE jumper is closed. When the ERASE jumper is open, we see 2 volts on VDDCORE (which is out of spec.), the crystal isn't oscillating and the JTAG TAP controller isn't working.

Of course with the ERASE jumper closed, we cannot do anything with it other than watch the boot loader ROM running.

Re: SAM3U-EK available

Posted: Fri Jul 31, 2009 2:45 pm
by nat
Please follow this precedure:
To erase the Flash, connect ERASE Jumper during power-up.
Remove the Jumper and press Reset button (NRSTB pin).

if you still have issue contact at91 support team

Re: SAM3U-EK available

Posted: Sun Aug 23, 2009 10:14 am
by michael123
Replacement board received and is working OK so far.

Re: SAM3U-EK available

Posted: Thu Aug 27, 2009 10:57 am
by Anny.Lee09
There has a MP3 programmer run on SAM3U-EK which could play .wav and .mp3 audio file.
The programmer base on a free OS called Coos,it is similarity to RTX and UCOS.

You can get the source file of MP3 programmer from http://www.coocox.org/EXAMPLE/SAM3U_MP3_CoOS.htm