I wanna test the high speed usb interface of SAM3.
On the microcontroller I use 2 endpoints for Interrupt in and out.
On pc I use the example of Winusb from http://www.lvr.com/winusb.htm
The device sends 1024Bytes to the PC. The PC can get the right data. But the speed is very low.
the device is recognized by pc as high speed device. In the oscillograph the microframe is right with a 125us interval.
"Bus Hound" shows that the phase IRP occupy the most time.
Where can be the problem?
Thanks in advance!
Discussion around product based on ARM Cortex M3 core.
3 posts • Page 1 of 1
Don't use interrupt pipes
Who is online
Users browsing this forum: No registered users and 4 guests