new sam3u-ek

Discussion around product based on ARM Cortex M3 core.

Moderators: nferre, ncollot

snowling
Location: michigan, usa
Posts: 9
Joined: Thu Jul 12, 2007 9:40 pm

new sam3u-ek

Sun Apr 25, 2010 7:02 pm

I have a new sam3u-ek that does not show up when attached through usb to my pc, I am using usbview to verify. I am also getting 'No valid processor ID found' when trying to use sam-ba which is showing only com ports. I have installed isp v113 and have installed the patch. I have read the manuals and have no problems with my at91sam7a3-ek or 9g45-ekes boards.
Any suggestions as this is making it hard to convince my client that this is the board to use for development.
snowling
Location: michigan, usa
Posts: 9
Joined: Thu Jul 12, 2007 9:40 pm

Re: new sam3u-ek

Thu Apr 29, 2010 10:50 pm

To save anyone else out there the wait and frustration; to solve this problem you need to find the 'AT91Sam3U-EK Test Software' document. This will explain how to get your new board working, as you probably received it with the jumpers in the wrong positions for a quick start. I did. This information was provided previously in the 'Getting Started Guide' on the Atmel web site in the section pertaining to the respective Evaluation Kit.

Return to “SAM3 Cortex-M3 MCU”

Who is online

Users browsing this forum: No registered users and 2 guests