I have been working on converting the example bootloader Atmel have for the SAM3 and I keep having nothing but problems but that is another story.
I am just wondering if it is possible to have Atmel Studio using JTAG to upload the bootloader into both flash0 and flash1.
I keep having to compile it and then manually use SAM-BA to upload the .bin into the two different locations (0x80000 & 0xC0000). As I am trying to debug this is taking up a lot of my time.
Thanks in advance.
Discussion around product based on ARM Cortex M3 core.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests