SAM-BA Boot Program does not enumerate

Discussion around product based on ARM Cortex M3 core.

Moderators: nferre, ncollot

wa4ywm
Posts: 9
Joined: Thu Feb 28, 2013 10:34 pm

SAM-BA Boot Program does not enumerate

Mon Dec 29, 2014 6:30 pm

I am using the SAM3S1B processor. I want to use the ROM bootloader communicating via the USB port. To enter the bootload mode from my application I clear the GPNVM bit 1 and then reset the processor with a software reset. No other action is taken. The device appears to go into the boot mode. However, I cannot communicate and when I check the enumeration using USB View I see that it has not enumerated. Is there something I'm not doing? Any ideas out there? Thanks.
man4pak04
Posts: 2
Joined: Mon Apr 27, 2015 2:41 pm

Re: SAM-BA Boot Program does not enumerate

Mon Apr 27, 2015 2:42 pm

The problem I have is that interrupt routine is called always one more time after the pin is driven high. I have a picture which shows the problem but I cannot attach it for some reason... I can send it to anyone interested








______________________________________
ANAIM

Return to “SAM3 Cortex-M3 MCU”

Who is online

Users browsing this forum: No registered users and 1 guest