My Atmel-ICE PCBA doesn't work with Atmel Studio 6.2.1153 on win8.1 x64 I can see debugger driver in device manager as Atmel/Atmel-ICE Data Gateway and in HID session two items(HID-compliant vendor-defined device, USB input device)(see figure below). Device work properly(information from win). But selected debugger/programmer tool list in Atmel Studio is still empty. I was try request atfw -l in command prompt, i got response: Connected tools: atmelice J41800000xxx Could you help me find some solution? I was tried reinstall Atmel Studio and USB driver without success. Debuger device is certainly ok. It was run correctly on win xp or win7
Discussions about all user software around SAM Series.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests