I have a custom board with a SAMA5D27 and an LCD with resistive touchscreen. This is using C code ("bare metal") rather than Linux.
The "softpack" has loads of useful examples and I have the board running, and graphics on the display etc. but there are no code examples for a resistive touchscreen (4 wire).
Before I plough through the datasheet and create my own library for this, does anyone happen to know of any code out there that I could use, either as-is or, at least, as a starting point? I've searched on here and not found anything, but apologies if there is and I've missed it.
Discussions about all user software around SAM Series.
4 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest