Page 1 of 1

DIY a emluator for SAM3U-EK

Posted: Fri Aug 28, 2009 9:20 am
by Anny.Lee09
Hi folks,
There is a kind of smart and open emluator -- CooCox Colink,which supports all Arm Cortex-M3 devices(include at91sam3u).

You can just do the hardware yourself,you can find the components you needed and the Circuit Schematic Diagram on http://www.coocox.org/How-to-do-Colink-plugin.htm

If you have finished the hardware,then you can download the plugin for Realview MDK and EWARM IAR from http://www.coocox.org/Colink.htm.

And then,you will have a emluator whose function is similar to ULINK2 and JLINK.You can use it under MDK or IAR.
Have a try,it is interesting and helpful.

Re: DIY a emluator for SAM3U-EK

Posted: Sat Aug 29, 2009 9:04 am
by sam_jion
Sounds good.I am going to get a SAM3U-EK board.It seems chould help me something.
Does it support any other device?

Re: DIY a emluator for SAM3U-EK

Posted: Sat Aug 29, 2009 11:00 am
by Anny.Lee09
Colink supports for the following devices:

ST STM32 Series
Atmel AT91SAM3U Series
NXP LPC17xx Series
Toshiba TMPM330 Series
Luminary LM3S Series