Page 1 of 1

SAM7-P256 boot problem

Posted: Tue Nov 24, 2009 12:56 pm
by scuzzy
Hi, I recently bought a SAM7-P256 devboard from Olimex. When I plugged it in, the board refused to accept any address given to it by the kernel. Then, I decided to try the SAM-BA boot loader thing with the following procedure:
1. Power Down
2. close the test jumper
3. power up and wait 10 seconds
4. power down, open the test jumper
5. power back up.

However, since I did this, the board doesn't respond to anything. If I plug it in, the computer doesn't even acknowledge that there is a device connected. Any ideas?

Thanks
Daine.