Our design is based on the 9263 eval board, and supports either 8 bit or 16 bit Nandflash. The 8 bit part works fine, but when the 16 bit part is soldered in and I Enable Nandflash in SAM-BA, I get:
Script Error: Can't detect known device
The device ID is in the list in NandFlashModelList.c, so shouldn't it be recognized? Do I need to edit a script or recompile an applet? Or is it likely to be a hardware problem?
Microchip in-system programming solution: SAM-BA
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 10 guests