Page 1 of 1

SAM-BA from the command line, need to program 3 at a time

Posted: Thu Aug 12, 2010 6:03 pm
by Bob Bailey
Hi. I have written some software to control our programming and test fixture. (in Visual C#) It calls Sam-Ba from within the program, and Sam-Ba executes my TCL using a board file I wrote to match the unit. Everything works except Samba will kill any other samba processes. I can't afford the time required to program these sequentially, as I have a Gig of NandFlash on the board.

Has someone else out there solved this issue? Is Sam-Ba truly open source, i.e. can I recompile it to not have this 'feature'? Or do I need to reinvent the wheel using the DLLs?

Thanks guys

Bob