SAMBA programming

Microchip in-system programming solution: SAM-BA

Moderators: nferre, fab

Location: chennai
Posts: 14
Joined: Fri Apr 06, 2007 1:43 pm

SAMBA programming

Sat Jun 30, 2007 3:47 pm

i am using the AT91SAM7S64 for programming the flash i am using the SAMBA program for interfacing but when i select the com1 and the board name . i get a fatal error saying " no valid processor ID found" so wts is the problem in it how can i download the bin file into the chip tried using the usb also but no result

plz help
Location: ATMEL Rousset France
Posts: 17
Joined: Thu Aug 17, 2006 9:46 am

SAM7S "no valid processor ID found"

Mon Jul 02, 2007 8:34 am


The problem here is that SAM-BA cannot communicate with the chip.

1/ Be careful that on the SAM7S the ROM code is running in FLASH, so once you have programmed a file in flash, you won't be able to use SAM-BA without doing a recovery procedure (this erases the flash and recovers the ROM code in flash).

2/ The serial link used is the DBGU on the SAM7S side. Don't plug the USB cable if you intend using the COM port.

I hope this will help you :-)

Best regards,


Return to “SAM-BA”

Who is online

Users browsing this forum: No registered users and 1 guest