SAM-BA does´nt work...pleas help urgnetly...

Microchip in-system programming solution: SAM-BA

Moderators: nferre, fab

Posts: 82
Joined: Tue Jun 26, 2007 6:27 pm

SAM-BA does´nt work...pleas help urgnetly...

Wed Sep 19, 2007 7:06 pm


My Problem:
I do the following steps:
1.) Voltage OFF
2.)Drive PA0,PA1,PA2, TST Pins HIGH (3,3V)
3.)Voltage ON
4.)TST = LOW; PA0,PA1,PA1 = unconnected
5.)Voltage OFF
6.)Voltage ON

Now the SAM-BA Boot Mode must be enabled, but is isn´t. The DBGU ist initialiszed. The DTXD Pin falls from 3,3V to 2,8V.(Not initialized as an Output).
There is no voltage on the PLL Filter...

On another Board Layout it´s working??? but why???
Microcontroller = AT91SAM7S128
XTAL is standard 18,34 MHz...PLL Filter 1,5k, 1nF 10 nF...(Standard)

What could be the problem ?

Which Pins are ALWAYS necessary, which PINS are checked at the beginning of SAM-BA boot mode initialization...

please help, I Don´t now how to go on...
Location: Poland
Posts: 17
Joined: Tue Apr 03, 2007 3:05 pm

Fri Sep 21, 2007 3:36 pm

How long do You wait beetween step 3 and 4 ? - according to Atmel's documentation it takes at least 10 seconds to copy SAM-BA boot code from internal ROM to the first two sectors of FLASH.


Return to “SAM-BA”

Who is online

Users browsing this forum: No registered users and 2 guests