how to execute program after programming?

Microchip in-system programming solution: SAM-BA

Moderators: nferre, fab

at91sam9263
Posts: 4
Joined: Tue Nov 20, 2007 11:32 am

how to execute program after programming?

Tue Nov 20, 2007 11:54 am

Hi,

I have been thinking how to start execute the code after programming it into SDRAM/SRAM. Usually I program the code to internal flash and press reset button to start running (AT91SAM7S).

Anyone know how to make this happen?

Thanks.
at91sam9263
Posts: 4
Joined: Tue Nov 20, 2007 11:32 am

Thu Nov 22, 2007 2:39 am

Maybe this is a stupid question to answer so nobody reply. Anyway I just found my answer -> TCL_Go.

Thank you.
nigschs
Posts: 3
Joined: Mon Nov 05, 2007 12:22 pm

Sun Nov 25, 2007 12:55 pm

Hello!

Perhaps you can help me!
Are you using this dll from ATmel to load the application to the flash?
I had the problem, that i want to use this dll in .net. but the demo-source and dll is written in cpp. Now i had the problem that i can´t use this dll in C#! Propably you can tell me how you will use this?

Thanks

Simon
at91sam9263
Posts: 4
Joined: Tue Nov 20, 2007 11:32 am

Sun Nov 25, 2007 3:21 pm

Hi,

I'm using SAMBA to downlaod the program with TCL command to execute the code. Sorry I've no idea on the dll.

Perhaps someone who read this thread can help u.

Return to “SAM-BA”

Who is online

Users browsing this forum: No registered users and 3 guests