Page 1 of 1

How to program AT91SAM7S256 with USB

Posted: Thu Feb 19, 2009 8:55 am
by slawek7
Please help me because i dont know what is heppening.
I have a board whith AT91SAM7S256. I've tried to program it whith SAM-BA and by connecting to USB.
I did all what was written in instruction.
I connected pin TST to H, turned on power, and waited about 10sek, then I switched it off, taked off the jumper, turned it on, and connected to USB port in my PC.
At this time the PC sholud find a AT91xx TEST BOARD, but it still telling me that cannot recognize USB device.

What can I do. I dont know what is going on?

Please help me?

Re: How to program AT91SAM7S256 with USB

Posted: Sat Feb 28, 2009 3:38 pm
by gpouly
Hi,

You can try to connect your board to another USB port. Something wrong may happen during the driver setup.