SAMA5D2-ICP board will be available by mid-March 2020

Moderator: nferre

nferre
Site Admin
Posts: 218
Joined: Wed Feb 14, 2007 11:17 am

SAMA5D2-ICP board will be available by mid-March 2020

Thu Feb 13, 2020 1:05 pm

Hi,

The SAMA5D2-ICP board will be available by mid-March 2020.
You can find Linux4SAM material ready for it on the usual http://www.linux4sam.org pages.

Best regards,
Nicolas
RedAuto
Posts: 3
Joined: Fri May 29, 2020 3:41 pm

Re: SAMA5D2-ICP board will be available by mid-March 2020

Fri May 29, 2020 3:49 pm

Hello, I've just received this board, but when I use J-Link OB, I can't connect to SAMA5D27.
J19 and J20 are opened.

Code: Select all

Opening J-Link with S/N '483084262'
Error: Unsupported device
What's wrong?

Thanks!
nferre
Site Admin
Posts: 218
Joined: Wed Feb 14, 2007 11:17 am

Re: SAMA5D2-ICP board will be available by mid-March 2020

Fri May 29, 2020 6:01 pm

Hi,

Can you upgrade the Segger Firmware by running the latest J-link commander / command line tool (available on Linux as well)?
https://www.segger.com/products/debug-p ... commander/

Hope that it helps.
Best regards,
RedAuto
Posts: 3
Joined: Fri May 29, 2020 3:41 pm

Re: SAMA5D2-ICP board will be available by mid-March 2020

Sat May 30, 2020 9:52 am

Hi,
Thank you for the reply, I've upgraded J-Link but error the same.

I use J-Link on board.
Thanks!
RedAuto
Posts: 3
Joined: Fri May 29, 2020 3:41 pm

Re: SAMA5D2-ICP board will be available by mid-March 2020

Sat May 30, 2020 10:59 am

Hello,
Another J-Link says:

Code: Select all

Connecting ...
 - Connecting via USB to J-Link device 0
 - J-Link firmware: J-Link ARM V8 compiled Nov 28 2014 13:44:46
 - Device "ATSAMA5D27" selected.
 - Target interface speed: 10 kHz (Fixed)
 - VTarget = 3.190V
 - ConfigTargetSettings() start
 - ---Setting ETB available---
 - ---Setting ETB Base Address---
 - ---Setting ETM Base Address---
 - ConfigTargetSettings() end
 - Could not measure total IR len. TDO is constant high.
 - ConfigTargetSettings() start
 - ---Setting ETB available---
 - ---Setting ETB Base Address---
 - ---Setting ETM Base Address---
 - ConfigTargetSettings() end
 - Could not measure total IR len. TDO is constant high.
 - Executing init sequence ...
  - ERROR: Could not perform target reset
 - ERROR: Failed to connect.
Could not perform custom init sequence.

Return to “SAMA5-based”

Who is online

Users browsing this forum: No registered users and 6 guests