Hi there,
I am working on a project with a SAM3U4C and I am using Atmel Studio 6 as the development tool.
In AS6, I created a new User Board based on this processor. Right after the project setup completion (without any addition to the sources) and compiling the project, it uses already ~36% (~17k) of my available SRAM. I can´t figure out where the demand of SRAM is coming from. Any ideas?
(Changing the optimization has no influence on the SRAM demand).
Thanks and Best Regards,
Alex
Atmel Studio 6, User Board, SAM3U, SRAM use
Moderator: nferre
Who is online
Users browsing this forum: No registered users and 3 guests