Hello,
I'am trying to dump the memory of one of my G25 based board, to flash it to another G25 based board, both with SAM-BA and a Atmel SAM-ICE.
With PMECC, there are errors detected when starting the flashed board. With software ECC, I have an error on the first block I'm trying to dump. Without ECC, nothing but ROMBOT when starting the board.
So, PMECC seems the best, but I think I have a wrong configuration. (number of sector, size for ecc sector, offset...)
Is there a way to get the ECC configuration of the board I would like to dump?
Where can I found correct configuration? (changing only one parameter result in an "header configuration failed" error)
Thanks
Get ECC configuration with SAM-BA
Moderator: nferre
Post
Re: Get ECC configuration with SAM-BA
It is up to the user to configure the PMECC parameters correctly, so you have to refer to the datasheet of the nandflash you use.
Who is online
Users browsing this forum: No registered users and 1 guest