I have adopted an AT91SAM7X256 SW written under a “non-KEIL” IDE.
That SW currently runs OK on an ATMEL SAM7X-EK (Evaluation Kit).
I simply need to convert that SW to our development environment, which is:
- AT91SAM7X256 (same MCU)
- KEIL uV22.214.171.124
- The board_cstartup.S must NOT contain auto-vectoring for IRQ (but a branch to local “irqHandler”)
- I use a simple memory model with only SRAM “RW” + “ZI” (stack, but no heap, no C-alloc needed (I assume))
- ULINK2 debugger (assume that info is irrelevant)
I would very much appreciate a link to (or actual code) a framework for this configuration.
This seems like a trivial task, but I cannot find a “perfect match” which does not generate all kinds of different (linker) problems.
Regards Terje Bøhler
All design tool related questions: compiler, assembler, linker. Embedded programming questions: assembler, C code.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest