I'm using a SAM D20 Xplained board and trying to get the emulated eeprom to work. I can't figure out where and how to set the fuses to reserve some of the flash space for eeprom emulation. I've checked all of the menus for a fuse read/write tool like in the old Atmel Studio 4.x and I don't see anything. Can someone point me in the right direction?
All design tool related questions: compiler, assembler, linker. Embedded programming questions: assembler, C code.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests