Page 1 of 1

Atmel Studio 6.2 for SAM4N Watch window does not show hex

Posted: Tue Aug 25, 2015 7:11 am
by berntd

I am not sure where this needs to be reported but it urgently needs to get fixed.

The debug watch windo shows watched variable values only in decimal.
No nmatter if the hexadecimal is ticked or not.

I noticed that there was an ASF Bugzilla entry (BUG 3392) for apparently just bout the same issue in 6.2 Beta and it was listed as resolved.

I am not able to start a new report there.

Who look into that?

Best Regards