I have tried using sam-ba 3.1.3 with Debian 8.5 and windows 10. For both operating systems I get the error as indicated above about switching to binary mode.
Does anyone know what this is occuring and is there a solution.
I have tried this on VirtualBox v5.1.2 running Debian 8.5 guest on a Windows 10 host, a Linux Machine also running Debian 8.5, and a windows 10 machine. all three have the same error.
Regards
Lachlan
sam-ba 3.1.3 Error: Could not switch monitor on port 'xxx' t
Moderator: nferre
Post
Re: sam-ba 3.1.3 Error: Could not switch monitor on port 'xx
Have you tried opening a normal serial port with the device connected?
Post
Re: sam-ba 3.1.3 Error: Could not switch monitor on port 'xx
Thanks for your reply.
I finally determined that I need to hold a button down on the board on reset to bring the processor up with the port in Binary mode.
Problem solved.
Thanks for your help.
I finally determined that I need to hold a button down on the board on reset to bring the processor up with the port in Binary mode.
Problem solved.
Thanks for your help.
Post
I am having the same problem. Can you elaborate further how you solved your problem?
Thanks
Elyas
Re: sam-ba 3.1.3 Error: Could not switch monitor on port 'xx
Hi,
I am having the same problem. Can you elaborate further how you solved your problem?
Thanks
Elyas
Who is online
Users browsing this forum: No registered users and 1 guest