Reset board from Samba

Discussion around AT91RM9200 and SAM9 Series Products.

Moderator: nferre

Posts: 2
Joined: Tue Mar 19, 2013 6:16 pm

Reset board from Samba

Wed Mar 20, 2013 6:02 pm

What is the correct way to reset a target board and run the uploaded firmware after flashing with Sam-ba?

The target is a custom board using internal flash only, the application is a factory test. So I would like to script (using python, command line Sam-ba and tcl scripts) the following procedure:

1. Program the target
2. Reset target and cleanly exit samba
3. Run test firmware

without power cycling the board. A hardware reset would be OK, though not optimal. Simply toggling NRST doesn't work though.

Can this be done with the standard samba tcl scripting?

Return to “SAM9 ARM9 MPU”

Who is online

Users browsing this forum: No registered users and 4 guests