SAM-BA V2.6 with older J-Link

Microchip in-system programming solution: SAM-BA

Moderators: nferre, fab

ATTILA
Location: Hungary
Posts: 2
Joined: Mon Sep 10, 2007 9:28 am

SAM-BA V2.6 with older J-Link

Mon Sep 10, 2007 9:43 am

Hi Folks,

I have bought a AT91SAM7S64-EK IAR evaluation KIT a few years ago (2004). This comes with a J-LINK.

I am trying to use this J-LINK with SAM-BA 2.6, but I always get the following warning message:

"The connnected J-Link does not support adaptive clocking. JTAG speed remain at 5kHz".

This is right because this device older. Hardware version is only 3.0. However I don't like to throw out it. Because of this speed is very slow, this solution is unusable for me.

With fix, or auto speed mode I can use it up to 4000kHz (or 2666kHz) under IAR EWB or Eclipse. The speed depends on used JLinkARM.dll.

I there any solution to operate my J-LINK on higher speed via SAM-BA?
How can I turn off the adaptive clocking mode?

Thanks in advance.
gerhardf
Posts: 554
Joined: Thu Dec 02, 2004 2:28 pm

Mon Sep 10, 2007 10:23 am

hello,
you have to update the firmware of the j-link:

-) download the latest version from:
http://www.segger.com/download_jlink.html

-) start JLink.exe. this will update the firmware of j-link

regards
gerhard
ATTILA
Location: Hungary
Posts: 2
Joined: Mon Sep 10, 2007 9:28 am

Mon Sep 10, 2007 11:16 am

Hi gerhardf,

This was made yet. I have downloaded the latest firmware and I have made an upgrade. It was successful. Unfortunatelly the adaptive clock feature is not SW feature. That is HW. I get this answare from Segger.

So, the only way, if I could config SAM-BA, or SAM-PROG, that it doesn't use adaptive clocking.

Any idea?

Return to “SAM-BA”

Who is online

Users browsing this forum: No registered users and 7 guests