Here are the kernel messages when i plug a webcam in:
Code: Select all
hub 1-0:1.0: state 5 ports 2 chg 0000 evt 0002
at91rm9200-ohci at91rm9200-ohci: GetStatus roothub.portstatus [0] = 0x00010101 C
SC PPS CCS
hub 1-0:1.0: port 1, status 0101, change 0001, 12 Mb/s
hub 1-0:1.0: debounce: port 1: total 100ms stable 100ms status 0x101
at91rm9200-ohci at91rm9200-ohci: GetStatus roothub.portstatus [0] = 0x00100103 P
RSC PPS PES CCS
usb 1-1: new full speed USB device using at91rm9200-ohci and address 6
at91rm9200-ohci at91rm9200-ohci: GetStatus roothub.portstatus [0] = 0x00100103 P
RSC PPS PES CCS
usb 1-1: ep0 maxpacket = 8
usb 1-1: skipped 3 descriptors after interface
usb 1-1: skipped 2 descriptors after interface
usb 1-1: skipped 1 descriptor after endpoint
usb 1-1: default language 0x0409
usb 1-1: new device strings: Mfr=1, Product=2, SerialNumber=0
usb 1-1: Product: USB Camera
usb 1-1: Manufacturer: OmniVision Technologies, Inc.
usb 1-1: hotplug
usb 1-1: adding 1-1:1.0 (config #1, interface 0)
usb 1-1:1.0: hotplug
usb 1-1: adding 1-1:1.1 (config #1, interface 1)
usb 1-1:1.1: hotplug
usb 1-1: adding 1-1:1.2 (config #1, interface 2)
usb 1-1:1.2: hotplug
hub 1-0:1.0: state 5 ports 2 chg 0000 evt 0002
Is there something i should be configuring in the kernel?
Thanks,
Layton