Hi
When using the sam-ba ver 2.9 or sam-prog ver 2.4 with the sam3u4-ek development board and either the sam-ice or rs232 I get the following error: "No valid processor ID found"
any ideas ?
Yvon
no valid processor id found [solved]
Post
Re: no valid processor id found
Hi,
I use sam-ba v2.9 for at91sam3u4-ek yesterday.It works very well.
Check your supply power and this web may help you.
http://www.atmel.com/dyn/products/tools ... ol_id=3883
I use sam-ba v2.9 for at91sam3u4-ek yesterday.It works very well.
Check your supply power and this web may help you.
http://www.atmel.com/dyn/products/tools ... ol_id=3883
An RTOS specially for Cortex-M3----> http://www.coocox.org
Post
Re: no valid processor id found
Hi
Thanks problem was resolved. (Use of Erase pin, jumper JP1).
Yvon
Thanks problem was resolved. (Use of Erase pin, jumper JP1).
Yvon
Return to “SAM3 Cortex-M3 MCU”
Who is online
Users browsing this forum: No registered users and 3 guests