This forum is for users of Microchip MPUs and who are interested in using Linux OS.
1 post • Page 1 of 1
I have custom board. It has Ethernet connection schematics just the same as on reference DK board with DM9161A tranciever. I am using kervel 220.127.116.11. Everything fine, except one annoing problem. When booting kernel everything fine. Then if I disconnect Eth cable, kernel reports LINK DOWN. When I reconnect, LEDs on the RJ45 socket are on, but kernel does not recognise, that connection is established. When I again disconnect cable, it reports Link 100Mbps (or similar) and immideately Link Down. So as a result, if to some rason cable is disconnected, I have to reboot the device to reenable the connection, which is of cause anacceptble. Did anobydy met the problem.
Who is online
Users browsing this forum: Google [Bot] and 0 guests