Hi evrybody,
A new release of the AT91 PLL calculator tool is available:
- introduction of new products
- improve the help of the tools
- display errors corrected
http://www.atmel.com/dyn/resources/prod ... R_AT91.xls
- Best Regards -
PLL Filter Calculator update
Moderator: nferre
- stephan_cadene
- Contact:
- Location: Atmel Corp.
Post
PLL Tool not correct for EVB Example
DO YOU KNOW,
if you put in the figures of the components of the Atmel SAM7 EVB then the tool will be complaining.
ONE of them MUST BE WRONG !!!
What do say?
Regards
Thomas
if you put in the figures of the components of the Atmel SAM7 EVB then the tool will be complaining.
ONE of them MUST BE WRONG !!!
What do say?
Regards
Thomas
Post
Why can't I select from the full range of MUL and DIV values?
It looks like it's trying to be too clever and limit what I can choose to limit the output frequency, but it seems to be too restrictive.
I'm using the 'SAM7S and 'SAM7X with an 18.432 MHz crystal, and generating a 48MHz clock with MUL = 124 and DIV = 24, which as far as I know is legal (and it works), but this tool won't let me select these values...
Why?
Nick
It looks like it's trying to be too clever and limit what I can choose to limit the output frequency, but it seems to be too restrictive.
I'm using the 'SAM7S and 'SAM7X with an 18.432 MHz crystal, and generating a 48MHz clock with MUL = 124 and DIV = 24, which as far as I know is legal (and it works), but this tool won't let me select these values...
Why?
Nick
Post
Ok folks!
I still can't open this excel page.
Can anyone who have downloaded succesfully this XLS file , forwarded to me at my mailID?
krunal_299@yahoo.co.in
I still can't open this excel page.
Can anyone who have downloaded succesfully this XLS file , forwarded to me at my mailID?
krunal_299@yahoo.co.in
Who is online
Users browsing this forum: Majestic-12 [Bot] and 0 guests